patchwork quilt | organised castle

I have put my head down and done some concentrated sewing over the past couple of days. It is a birthday gift for our elder granddaughter.

The result is that I have now completed 21 patchwork blocks which is half of the total needed for a QS quilt.

I wrote a post in February which you can read here in which I mentioned that I had done the first block.

Here are the other 21 blocks ready to start sewing.

The disappearing 9 patch is essentially a 2-step process. The first is to sew the 9 pieces together and you can see some of them here at that stage.

After that, each block is cut into 4 pieces and rearranged before restitching. This gives the overall random finished pattern.

I hope to have the patchwork completed in the next week or so but it is somewhat dependant on other activities.

I began a new sewing project today. This is the first block of a patchwork quilt I am making for my elder granddaughter. It is for her 18th birthday in December. One block done, 41 to go.

Most of the fabric has been randomly collected from op shops and offcuts from various previous sewing adventures. However, there will be some from a particularly special piece. The small pale pink squares have history. They are from some leftover fabric from a dress which my mother made for herself – probably close to 30 years ago. From those leftovers I made a dress for my granddaughter which she wore on her first birthday.

This is not a great photo but you get the general idea. It was from an Enid Gilchrist pattern which I had made many time before and numerous times since.

The other patchwork was for the boxer shorts which I mentioned in my last post. I had rather optimistically thought that it would be a simple matter of adding a strip of fabric into the side seams and a bit at the top to extend the overall length of the crotch.

As I began to unpick the side seams it became obvious that the construction method was appalling and regardless of any alterations that I might make, the existing seams were not robust enough to stand up to much wear at all. So, I altered my plan and unpicked the entire garment. By this time it became obvious why they were not a great fit. The pieces bore only minimal resemblance to the pattern I had.

I used the excess length of the original trousers to add pieces to be able to recut all of the pieces for the boxer shorts using my own pattern. I used flat felled seams for joining the extra pieces as well as the main construction as I always do. These seams are great as there are no raw edges on the inside as well as being extra strong due to the two rows of stitching.

This photo shows the randomly joined pieces of fabric before I cut out the pattern pieces. I did not have enough fabric nor the desire to match the pattern.